Monday, May 3, 2021

Aircraft Engine Lubrication Systems

As the gas turbine engines have limited number of moving components their lubrication requirements are much simpler to meet. This is because the oil does not lubricate any parts that are directly heated by combustion (i.e Combustion chambers, Turbine Blades/Vanes...etc) 

However, for a sustained and prolonged operation, the engine requires ample supply of lubricating oil at all the bearings, gears and driving splines. This supply should be a continuous flow of clean filtered oil and an appropriate temperature, pressure and viscosity, throughout the engine operation.
Main goals of  engine lubricating oils are to:
  •         Lubricate
  •         Cool/ carry away the heat
  •         Prevent corrosion
  •         Resist oxidation at high temperatures
  •         Possess suitable viscosity at all operating temperatures
Gas turbine engines uses specially formulated low viscosity synthetic oil that does not originate from mineral oil. military specification MIL-PRF-7808 commonly referred as Type I jet oil and MIL-PRF-23699 commonly referred as Type II Jet oil are some examples of such synthetic aviation oils. It is essential that only those oils specified by the engine manufacturer are used. 
 
The ultimate decision of which oil to be used is decided by the operation characteristics and the loads of the engine including the bearing temperatures. Often the selection of the appropriate type of oil is a results of multiple engine tests and lab analysis of the oil. There are wide range of components being used in the lubrication system and basic overview is given in the below diagram. More details of each components will be discussed in later posts.

Following video is created to provide overview of the lubrication system : 



 
 


Follow Aviamech Blog