Tuesday, April 16, 2013

The Turbine Section

The turbine is the unit providing the power to drive the compressor and accessories and, in the case of engines which do not make use solely of a jet for propulsion, of providing shaft power for a propeller or rotor. It does this by extracting energy from the hot gases released from the combustion system and expanding them to a lower pressure and temperature.  High stresses are involved in this process, and for efficient operation, the turbine blade tips may rotate at speeds over 450m/s.  The continuous flow of gas to which the turbine is exposed may have an entry temperature between 1000 and 2000 deg.C. and may reach a velocity of over 750m/s when being passed in the turbine.To produce the torque, the turbine may consist of Several stages each consist of set of rotors and stators.

The torque or turning power applied to the turbine is governed by the rate of gas flow and the energy change of the gas between the inlet and the outlet of the turbine blades.  The design of the turbine is such that the whirl will be removed from the gas stream so that the flow at exit from the turbine will be substantially 'straightened out' to give an axial flow into the exhaust system. Excessive whirl reduces the efficiency of the exhaust system and also tends to produce jet pipe vibration which has a detrimental effect on the exhaust cone supports and struts and results in noise.

It will be seen that the nozzle guide vanes and blades of the turbine are 'twisted', the blades having a stagger angle that is greater at the tip than at the root.  The reason for the twist is to make the gas flow from the combustion system do equal work at all positions along the length of the blade and to ensure that the flow enters the exhaust system with a uniform axial velocity.  This results in certain changes in velocity, pressure and temperature occurring through the turbine.


1 comments:

best assignment help said...

Your post is very useful, good and informative for the people relating to aircrafts or aviation industry. You have defined in detail and hope to read more about flying machines in future.

Post a Comment